Gojar MEGUM is a one-coat bonding agent for bonding fluoro-carbon rubbers to metals and other rigid substrates during volcanization. Loctite is ideal for large depth potting, bonding of a wide variety of clear and translucent plastics and metals. Questions or comments about MatWeb? It used as a water retaining agent in cement based or gypsum based dry mortar products to improve the open time, workability, adhesion strength and sag resistance. It is also approved for use on bearings.
|Published (Last):||12 April 2018|
|PDF File Size:||8.36 Mb|
|ePub File Size:||11.95 Mb|
|Price:||Free* [*Free Regsitration Required]|
In some cases these aqueous washes can affect the cure and performance of the adhesive. For best performance bond surfaces should be clean and free from grease. Application To ensure a fast and reliable cure, Activator should be applied to one of the bond surfaces and the adhesive to the other surface.
Parts should be assembled within 15 minutes. The recommended bondline gap is 0. Where bond gaps are large up to a maximum of 0. Parts should be assembled immediately within 1 minute. Bond should be held clamped until adhesive has fixtured. Product should be allowed to develop full strength before subjecting to any service loads typically 24 to 72 hours after assembly, depending on bond gap, materials and ambient conditions.
Curing Cure Speed vs. Substrate - The rate of cure will depend on the substrate used. See Vendor technical data sheet for more information. Clean-Up Excess adhesive can be wiped away with organic solvent. Testing This product is not normally recommended for use on plastics particularly thermoplastic materials where stress cracking of the plastic could result. Users are recommended to confirm compatibility of the product with such substrates. Comparable Materials for Henkel Loctite
Loctite 3874 Technical Data Sheet
Loctite 3873 Technical Data Sheet
Henkel Loctite 3873